" Do not place carbonated or fizzy drinks in the" There are working parts in this product which
Quitar las escuadras y marcar a 8 mm del borde
freezer as it creates pressure on the container,heat up. Always ensure that there is adequate
which may cause it to explode, resulting inexterno de la puerta con el clavo (K).ventilation as a failure to do this will result in
damage to the appliance. Do not use acomponent failure and possible food loss. See
mechanical device or any artificial means toinstallation instructions.
speed up the thawing process other than those
" Parts which heat up should not be exposed.
recommended by the manufacturer. Never use
Wherever possible the back of the product should
metal objects for cleaning your appliance as it
be against a wall.
may get damaged.
InstallationEnvironment Protection
" During normal operation, the condenser and
This appliance does not contain gasses which
compressor at the back of the appliance heat up
could damage the ozone layer, in either its
considerably. For safety reasons, minimum
refrigerant circuit or insulation materials.TheEn caso de que sea necesario alinear la puerta del
ventilation must be as shown in the instructions.
appliance shall not be discarded together withmueble, utilizar el juego de los agujeros de ojal.
Attention: keep ventilation openings clear ofthe urban refuse and rubbish. Avoid damaging
Al término de las operaciones es preciso controlar
obstruction.the cooling unit, especially at the rear near the
que la puerta del aparato esté cerrada
heat exchanger. Information on your local
" Care must be taken to ensure that the appliance
correctamente.
disposal sites may be obtained from municipal
does not stand on the electrical supply cable.
authorities.The materials used on this appliance
Important: if the supply cord is damaged, it must
marked by the symbol are recyclable.
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
" If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
Introducir la tapa (Hd), presionándola hasta oÃr el
wait at least two hours before connecting the
resorte, en la guÃa (Hb)
appliance to allow the oil to flow back in the
compressor.
CONTENTS
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29
El aparato está provisto de dos escuadras (G) para
Use - Cleaning the interior - Operation - Temperature regulation - Fresh food refrigeration . . . . . . . . . . . . . . . .31
fijarlo lateralmente al mueble; para su aplicación ver
Use - Food protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .32les indicaciones de la Fig.
Use - Freezing fresh food - Storage of frozen food - Thawing - Ice-cube production Movable shelves . . . . . . .Montar las caperuzas (H).
Positioning the door shelves - . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .33
Hints - Hints for refrigeration - Hints for freezing - Hints for storage of frozen food - Freezing calandar . . . . . .34
Maintenance - Periods of no operation - Periodic cleaning - Interior light - Defrosting . . . . . . . . . . . . . . . . .35
Customer service and spare parts - Technical information - . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .36
Installation - Location - Shelf-holders - Electrical connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37
Installation - Building-in instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .38
Terminada la operación de reversibilidad de la
Installation - Inner door reversal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40puerta, controlar que la empaquetadura
magnética esté adherida al mueble. Si la
temperatura ambiente es frÃa (por ejemplo en
invierno), puede suceder que la empaquetadura
no adhiera perfectamente al mueble. En este
caso esperar que la empaquetadura se recobre
en forma natural o bien acelerar dicho proceso
calentando la parte interesada con un normal
secador de cabellos.
3015 |
ACEC
